Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Show

Hi.

It has some command where I can see percent bandwidth utilized? For example i want see how much of my link frame it is utilized.

Another question. It has some command where I can see the length of a packet, just one, em kbps?

2 REPLIES
New Member

Re: Show

Hi

If you want to monitor a link on the router without using snmp, you can simply use the show interface command, i would recomend changing the load-interval to 30. The figures over 255 show how busy the link is, 255 = 100%

Hope this helps

Silver

Re: Show

are you using switch (catOS) or IOS based device like router?

When you say 'Frame', do you mean frameRelay or ethernet frames?

Ajaz

85
Views
0
Helpful
2
Replies