I am unable to get to the user it goes to the receptionist. Currently if you call my client, it will go to the receptionist and then she will transfer the call. Is there something else I need to do to go directly to the user instread of going to the receptionist even though I am dialing the complete number with the last three of the user's extension.
If you have that range you can setup a dial-peer to the CCM, then in the CCM on the GW config page setup under incoming calls just setup the digits that you which to accept, last 4 digits, last 3 digits, etc.
if you do not have the same extensions you can setup a Translation Pattern to change the last 3 digits of your DID to the extensions.
You pretty much answered my question, but i will attempt to do what you stated above, but what would be helpful, can you give me examples of the syntex of how to do the dial peer and walk me through updating the translation pattern.
session target ipv4:192.168.100.2 (replace with your CCM's IP Address)
Then on the significant digits (GW config page in CCMAdim webpage) if you are using 3 digits extensions then just use 3 digits.
Then create a Translation Pattern. On the Translation Pattern field you will put 2XX, then under called party transform mask you must put the actual extension range. Make sure to assign a CSS that can reach the DN's partition.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.