Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Simultaneous Ring - voice hunt-group does not work

Hello all,

I have the request for simultaneous ringing while using a CME v 7.0, however the following configuration doesnt work:

!

voice hunt-group 2 parallel

final 3201

list 3201,85201,5201

pilot 5201

!

What we want is when someone calls 5201 to ring simultaneously to 5201, 3201 and 85201.

Any suggestions?

Many thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Simultaneous Ring - voice hunt-group does not work

What I am suggesting is that you cannot have hunt pilot and ephone-dn with the same DN as that creates a conflict and ephone-dn I believe will always be prioritized.  You need to either change the pilot DN to be something else or the ephon-dn to be something else.

Chris

3 REPLIES
Hall of Fame Super Silver

Simultaneous Ring - voice hunt-group does not work

Your best option would be to configure shared line appearance on the phones with ephone-dn 5201. If you do require hunt group then the pilot cannot be shared with another ephone-dn, you have both 5201 defined as pilot and a member.

HTH,

Chris

Simultaneous Ring - voice hunt-group does not work

Hello Chris, thanks for your reply

So what you suggest is to remove the dn 5201 from a member? For example,

voice hunt-group 2 parallel

final 3201

list 3201,85201

pilot 5201

ephone-dn  1

number 5201

label 5201

name George

description George

I think i have tried that already  and didnt work, is the above what you suggest to do?

Again thanks for your prompt response

Hall of Fame Super Silver

Simultaneous Ring - voice hunt-group does not work

What I am suggesting is that you cannot have hunt pilot and ephone-dn with the same DN as that creates a conflict and ephone-dn I believe will always be prioritized.  You need to either change the pilot DN to be something else or the ephon-dn to be something else.

Chris

1281
Views
4
Helpful
3
Replies