Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SIP and FXO selection

 hi all;

 

I need my gateway to route the calls coming from 58XX extensions to PSTN SIP trunk

and to route the calles coming from 61XX extension to FXO lines

 

anybody had this scenario befor ?!

 

regards

 

1 ACCEPTED SOLUTION

Accepted Solutions

Yes you can do that, Youse

Yes you can do that,

 

Youse answer-adreess to match inbounf dial-peer and then apply translation rule on that,

using translation rule prepfix something to your DNIS that chosses your outbound dial-peer.

 

on the outbound dial-peer, once gain apply translation rule to remove prefixed digit, and Make DNIS as original.

 

There are lot many post on this topic, search for ANI based routing.

 

Regards

Chintan

1 REPLY

Yes you can do that, Youse

Yes you can do that,

 

Youse answer-adreess to match inbounf dial-peer and then apply translation rule on that,

using translation rule prepfix something to your DNIS that chosses your outbound dial-peer.

 

on the outbound dial-peer, once gain apply translation rule to remove prefixed digit, and Make DNIS as original.

 

There are lot many post on this topic, search for ANI based routing.

 

Regards

Chintan

4
Views
0
Helpful
1
Replies
CreatePlease to create content