guys urgent help me is needed as i am going nuts.....we have a router cisco 2821 which is connected to ACD (PABX) via E1 (ISDN) card.....now there are bunch of phones behind that ACD.....the router is connected over WAN to data centre to other router... firewall is behind that router which has a VPN session with cisco 2821 router (our router) behind that firewall there are couple of SIP based IVR servers connected.....all i want to know is when someone calls (from ACD) to the IVR servers what are the commands to verfiy that call is getting through (leaving the router).....i put a debug on router debug isdn q931 it shows the calling party no as well as to whome it calling but cant see that call is connected.....someone told me to put debug voip ccepi inout but the messages which comes on the router is i guess in a language which i dont understand??? i tried debug voip dialpeer and debug voice rtp but guys no help.......all i want is to confirm that teh problem is at firewall end or out end.....is the router forwarding the call or there is a problem with acd....i m going nuts plz help me out as its getting on my nerves :-)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...