01-09-2009 09:24 AM - edited 03-15-2019 03:25 PM
I have a sip dial-peer with destination-pattern 521T sending calls to a GSM gateway (QUESCOM). the normal calls are working prefectly, but when i tried to call 521*333 for example, the GSM gateway only receives 521 in other words the cisco gateway is stripping the * and the other numbers. Even if a put a specific dial peer with destination-pattern 521*333.
dial-peer voice 1 voip
destination-pattern 521T
preference 1
voice-class codec 1
session protocol sipv2
session target ipv4:10.1.1.1
dtmf-relay sip-notify
no vad
dial-peer voice 2 voip
destination-pattern 521*333
voice-class codec 1
session protocol sipv2
session target ipv4:10.1.1.1
dtmf-relay sip-notify
no vad
I trid usinf different DTMF relays with no luck, but i think is not a DTMF relay issue because i'm not pressing any number dureing the call. im just sendind the whole thing.
any advice will be appreciated.
01-09-2009 03:59 PM
Hi German
Have you tried to debug the SIP messages (deb ccsip messages)?
Dial-Peer 2 will not be used since 521T is a better match.
01-10-2009 08:57 AM
I used the above dial-peers separately with no luck in both cases. in every case the GSM gateway only got 521
01-10-2009 11:31 AM
You really need to check the SIP messaging. I tried this in the lab and my router was able to send the * in the SIP INVITE with the dial peers just fine.
hth,
nick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: