In my office we are using CCM R7.1 and all use FAC to made external calls, recently we had to install some SIP endpoints, but I found that SIP end points do not could enter FAC code, I'm missing something on the configuration? or just SIP end points can't support FAC.
thanks for your replay, I see that FAC will not be supported by SIP end-point, do we have something like that for SIP End points? Every day we are using more an more SIP, and it's hard to beleave that we can't use features like FAC. Any work around or maybe it's going to be supported on a future release
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...