Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SIP Gateway and CM 5.x

Is it possible to use a 2821 router as a voice gateway, using SIP trunks, for CM 5.x? Here is my situation, I have hit a wall trying to get DTMF relay to work correctly with CM 5.x and a SIP trunk that terminates in the CM server.

I have a 2821 router here, so I thought I would try to termnate the trunk in the router and use it as a gateway (similar to the way I terminate a PRI circuit in a voice gateway). I can not seem to get the gateway to produce any "endpoints", even though the router shows that the SIP service is "Up". A "show CCM" command shows the gateway as "Registering...".

I chose MGCP as the gateway protocol (over SCCP -- the only other choice).

If this can be done, can someone point me to a comprehensive configuration guide / example?

Thanks,

Brian

1 REPLY
Green

Re: SIP Gateway and CM 5.x

Yes you can, that would act as an IPIP GW.

You terminate the SIP side in 2811 and configure other dial-peers to point to CCM either via H323 or SIP. Dont use MGCP since we are not controlling Analog!Digital endpoints based on your description correct?

SIP -- 2811 SIP or H323 -- CCM

In CCM you configure either a sIP trunk or H323 GW using 2811 IP address.

150
Views
0
Helpful
1
Replies