Hi, I am new to VoIP world so I have a few questions on setting up SIP gateway. I have set up in my lab CUCM 7.0 and cisco 2811 router. I want all my international calls to be routed to the sip provider. On CUCM I have made a sip trunk to my router and created a route pattern 0.00! pointing to this trunk.
On router I made following configuration
voice service voip
authentication username XXXX password XXXX
retry invite 2
retry response 2
retry bye 2
retry cancel 2
registrar dns:XXXXX expires 3600
Should this be enough, or I need to make some extra configuration?
I will be very grateful for any help. Links to web sites or names for the books where setting up CUCM with SIP gateway router is explained will be also very helpful.
P.S. I just stumbled upon CUBE, do I need CUBE to create SIP gateway or it is not necessary.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...