Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SIP INVITE with SDP (CUCM 7.1(2))

Hi all,

Regarding Cisco docs:

Cisco Unified Communications Manager follows the procedures that are described in RFC 3261, 3262,

and 3264 to establish and clear down basic SIP calls. Often, on the outgoing side, Cisco Unified

Communications Manager will send out INVITE without SDP. This allows Cisco Unified

Communications Manager to discover the capabilities of both sides and provide media services in

between if necessary (for example, transcoding).

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/sip_msg/line_std/7_0_1/siplst70.pdf

Does it possible to configure CUCM to send INVITE with SDP ?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: SIP INVITE with SDP (CUCM 7.1(2))

Hi.

Go to "Trunk Configuration -> SIP Information" frame and change the value of "MTP Preferred Originating Codec" parameter.

WBR,

Dmytro

3 REPLIES
Cisco Employee

Re: SIP INVITE with SDP (CUCM 7.1(2))

Yes, check the MTP required in the SIP trunk

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: SIP INVITE with SDP (CUCM 7.1(2))

Thank you now sip invites come out with sdp.

But how can I change default codec on CUCM from g.711 u-law to g.711 a-law ?

New Member

Re: SIP INVITE with SDP (CUCM 7.1(2))

Hi.

Go to "Trunk Configuration -> SIP Information" frame and change the value of "MTP Preferred Originating Codec" parameter.

WBR,

Dmytro

3305
Views
5
Helpful
3
Replies