We currently are running CUCM 8.6 and have 1800+ SCCP phones in place. There was a new product purchased for AV that will require us to connect (2) IP7000 SIP phones to our Call Manager. I am not sure how configurtion of these phones would differ from configuring a new SCCP phone. Any help is appreciated
Thank you for info. I went to start and am actually stuck at Step 1. It says to add a new End User. I do not even have an option to add one. We use AD, but I do not want to use an AD account this conference room phone.
In 9.x and above you can have AD (LDAP) users and local users. In your 8.x version you'll need to add an user in LDAP/AD to do this unfortunately. Or maybe you can tie it to an existing end-user (AD) without a phone, etc to get it to work. Problem is if someone deletes that user then the phone may stop working. You'll also need a different end user for each 3rd party SIP device as if you use the same SIP digest user on multiple SIP phones that doesn't work.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...