Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SIP phone linksys in CME

Does any of you know how to configure a linksys's SIP phone in CME 4.X

5 REPLIES
Hall of Fame Super Gold

Re: SIP phone linksys in CME

On the cme, Configure voice register global, dn and pool. Under pool, mac address doesn't matter, configure username same as number, codec g711u.

On the phone via web, configure proxy and registrar with the cme address, username and password.

These are the minimum steps.

Hope this helps, please rate post if it does!

New Member

Re: SIP phone linksys in CME

Hi, I used this guide over at uc500.com:

http://uc500.com/files/CME-SIP-Config-Guidev3%20Oct%202007.pdf

Thanks to the Author Tony Huynh.

It helped me out. You dont need phone loads if you are using a Linkys SIP phone.

New Member

Re: SIP phone linksys in CME

Thanks Craig,

very useful information

New Member

Re: SIP phone linksys in CME

hi Craig,

I checked the guide you recommended but I could not register linksys's SIP phone.

some commands were not valid, I have CME 4.0

e.g. name, label

do you have an example of how did you configure one of your linksys phone.

regards

Hall of Fame Super Gold

Re: SIP phone linksys in CME

First, configure mode cme under voice register global. There are many posts here regarding that, use the search function.

278
Views
4
Helpful
5
Replies
CreatePlease to create content