We have configured a 2821 router with a SIP connection to a SIP provider. We want to configure SRST fall-back with a BRI interface. Outward dialing works but when we configure a dial-peer POTS with direct inward dial the SRST functions but the SIP connection failes. How to configure SRST with a SIP connection on a gateway?
Can you post the output from "show dial-peer voice summary"?
Can you "debug voice dialpeer inout" and "debug ccsip messages" and post the output?
I guessing either it's hitting the wrong dial-peer or the ANI in the SIP message is different and causing the INVITE to be rejected. Or, something else entirely, but the debugs should help point us in the right direction.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...