Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SIP SRST - Extension to Extension calling not working

 

Hi ,

I am facing problem during SIP SRST. We are using 2921 CME SRST router and SIP phones are getting registered on router in SRST mode.

But extn to extn calling is not working. I have attached show run of the router.

 

When i executed, below commands, i got error that "unable to access default file".

"application

  service alternate default "

 

Please guide me on this issue.

 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hello!For fallback from MGCP

Hello!

For fallback from MGCP u need: 

application 

  global

    service alternate default

You alrady have it

Do u have any problems with SCCP endpoints? Calls from SCCP to SIP?

Please, post 'debug ccsip messages' while trying to call.

 

Regards,

Kirill

 

 

2 REPLIES
Cisco Employee

Hello!For fallback from MGCP

Hello!

For fallback from MGCP u need: 

application 

  global

    service alternate default

You alrady have it

Do u have any problems with SCCP endpoints? Calls from SCCP to SIP?

Please, post 'debug ccsip messages' while trying to call.

 

Regards,

Kirill

 

 

New Member

 Hi Kirill,Thanks for your

 

Hi Kirill,

Thanks for your reply. As I mentioned earlier, I was getting error while configuring commands for MGCP fallback.

Actually I had executed commands in SRST mode when Gateway was not registered with CUCM ie MGCP was down, hence it was giving error for "Application.... global .. commands".

I reconfigured same configuration keeping gateway registered with cucm & reloaded the router. Post this, tested SRST n extension to extension calling starts working.

Thanks for your valuable time.

Rgds

Harshali Nirgun

270
Views
0
Helpful
2
Replies