SIP Trunk betwee Call Manager 8.x and Siemens High Path 3800 PABX
Good evening. I have configured SIP Trunk between CUCM and Siemens High Path 3800 PABX. But when i dial the extension to the phone connected to siemens PABX, i dont get any dial tone and it gets dropped after 15 secs. The same issue is from the call coming to phone registered to CUCM from Phone connected to PABX. Kindly Suggest.
Have you checked the Run on all active nodes option in SIP trunk and Route List configurations?
Can you check in RTMT Session Trace on which side is disconnecting the call and collect the ccm traces for a test call.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...