Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

sip trunk between cme 7.0 and ccm 4.1

hi, i am trying to make a sip trunk between a cme 7.0 and ccm 4.1, the ccm 4.1 already has a sip trunk working to an OCS, so i created a new one, but i had to change the ccm's incoming port to 5061, to create it.....!!so i want to know, how can i configure the cme to point the sip trunk (dial-peer sip), to the ccm's 5061 port.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: sip trunk between cme 7.0 and ccm 4.1

This command will also change the port used to send SIP traffic.

Hope this helps.

Brandon

3 REPLIES

Re: sip trunk between cme 7.0 and ccm 4.1

You can change the SIP port on the CME with the following commands:

sip-ua

listen-port

Be aware that this is a global configuration. All SIP dial peers will use the new port for SIP communications.

Hope this helps.

Brandon

New Member

Re: sip trunk between cme 7.0 and ccm 4.1

hi, but i dont need to change the listen port on the ccme, i need to send the ccme trafic to the port 5061.....because the ccm has configured to listen this port..... in resume, i need to send the SIP outgoing traffic from the ccme using the 5061 port

Re: sip trunk between cme 7.0 and ccm 4.1

This command will also change the port used to send SIP traffic.

Hope this helps.

Brandon

268
Views
0
Helpful
3
Replies
CreatePlease to create content