SIP trunk between CUCM 8.0.3 and Nortel CS1000 not displaying name
i have cucm 8.0.3 cluster and i integrate with Nortel CS1000. I have no issue with voice calls between the two system.
When calling from Nortel phone to Cisco phone i can see the name of the caller on cisco phone evenm before answering the call. When calling from Cisco to Nortel the display name on cisco phone is not showing until the called phone (Nortel) answer the call then i can see the name. I followed cisco documentation (check attached)
Re: SIP trunk between CUCM 8.0.3 and Nortel CS1000 not displayin
Can you perform a packet capture of the SIP packets and post it on here? The first thing to see is who's at fault: CUCM by not sending a name in the INVITE; or Nortel for not acknowledging it and showing it on the phone.
CUCM can perform the packet capture for you. SSH into the node that will be performing the call setup and type this command:
utils network capture file nortelsip count 100000 size ALL host all
The destination IP address should be the IP address you entered on the SIP Trunk Configuration page of CUCM.
After completing a call, pull the file using RTMT. There will be an option on the second page for Packet Capture Logs.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.