Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SIP Trunk between two CUCM cluster

Hi,

I have two CUCM culster (9.1.1.20000-5 and 9.1.2.10000-28 versions) with connectivity, I have configured an Inter-Cluster Trunk (Non-Gatekeeper Controlled), and patterns in the cluster A, but when I call to the other cluster I have a busy tone.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Hi there , Is it possible to

Hi there ,

 

Is it possible to post screenshots of the cluster configuration pages ?

 

Please make sure your route patterns are correct and each side of the trunk has a incoming CSS that can access the required phones on either side .

 

Thanks

Aaron

2 REPLIES
New Member

Hi there , Is it possible to

Hi there ,

 

Is it possible to post screenshots of the cluster configuration pages ?

 

Please make sure your route patterns are correct and each side of the trunk has a incoming CSS that can access the required phones on either side .

 

Thanks

Aaron

New Member

These are the cluster

These are the cluster configuration pages

Thanks

462
Views
0
Helpful
2
Replies
CreatePlease to create content