Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sip trunk down

Hi all,

We have a psenario having ccme conncted to remote end PBX through sip trunk.I can make voip calls from here to remote.I need a solution to reroute the calls through pstn automaticaly if this voip line is down.If anyone having solution for this please help me..any replies will be extremely valuable..

1 REPLY

Re: sip trunk down

This is fairly easy. Let's say you have an access code of 9 followed by 10 digits for all calls.

dial-peer voice 1 voip

description to pbx

session protocol sip

destination-pattern 9..........

codec g711ulaw

no vad

dtmf-relay rtp-nte

preference 0 (default)

dial-peer voice 2 pots

destination-pattern 9..........

port 0/0/0:15

preference 1

If you leave out the preference, these will have the same destination pattern and the gateway will load balance between them by default. By putting a higher preference value on the POTS dial peer it will not be routed to unless the first dial peer fails.

hth,

nick

120
Views
0
Helpful
1
Replies