I have two CME systems connected using a SIP trunk. In both systems, SCCP was used as a signaling protocol. In that situation all works properly. Then, all phones in one site are converted to SIP. Local calls on this site work properly, but calls across the SIP trunk don't work. When calling from SIP side to SCCP side, a reorder tone is heard. When calling from SCCP side to SIP side, the phone at the SIP side rings but no voice is heard.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...