cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3732
Views
25
Helpful
5
Replies

SIP Trunk test plan

Maleksalim
Level 1
Level 1

Hi,

Please can someone tell what's the procedure follow to test the SIP Trunk deployed with the provider.

Thanks.

5 Replies 5

abarkalg
Level 1
Level 1

In a simple way, Call a number with which matches full route pattern and have only the sip trunk in the "Available devices" in the route group. so you are forcing the call to take this specific trunk and see if the call completes.

Hope this helps.

-Abdul

Please rate helpful posts!!!

thak you  Abdul Sattar but what i am looking for is the full procedure from end to end

baskaranm
Level 1
Level 1

hi,

use dialed number analyser and do the test for call flow.

regards,

baskaran

Hi,

Below link shows best practice of SIP trunk for PSTn access. See if this helps in creating your test plan based on best practice.

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/gatecont/ps5640/white_paper_c11-620461.html

Below link shows you tested configuration with tested service provider.

http://www.cisco.com/en/US/solutions/ns340/ns414/ns728/networking_solutions_products_genericcontent0900aecd805bd13d.html

Not sure how much this will help you, But refering above doc will give you idea what to expect in SIP PSTN access.

regards

Ronak Patel

Please rate helpful posts

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.

Thank you patel it is really helpful

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: