i want to connect to a voip provider i have 7815 MCS and 2811 router with 1 M internet connection speed i want to add a SIP trunk link to this provider assume their target IP is 220.127.116.11 and udp port 5060
what steps do i need to configure this on both CCM 5.1 and 2811 router note that i have just to direct international calls through this link with all other calls to be terminated through another 2811 mgcp VGW ?
note that the 2811 in this case would be an IP-to-IP gateway (aka SBC) that requires a special image and license. So if could do so that the CCM trunks directly to the SIP provider, it would be probably be much easier.
If you do the direct trunk to the provider, the 2811 does the router and knows nothing about the calls, and is not an IP-to-IP gateway.
what steps do i need to configure this on both CCM 5.1 and 2811 router note that i have just to direct international calls through this link
can any one else help pleaaaase
thanks in advance
i think forum is for knowledge sharing from one who has knowledge to one who seeks knowledge
any way thanks for "SIP trunking" u could say to me google it.... it will be better!!
No, not google it. CCO search, powered by google :)
The point is that you didn't even done your due diligence in reading the manual, and are looking for others to solve your problem.
That pairs well with your attitude at ranking.
Once again, best luck!
i did CCOed it, the CCO powered by google, but did not get it
could u please send the link to me
again its not a my problem it is a knowledge sharing...
i hope everyone use forum for knowledge sharing not just only to collect points
Here's the link.
I don't care about ratings, but fairness, I do care.