Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sip trunks between two CCM 4.1.3

I have two locations and I am testing the following

- Sip trunk between them

Both locations have a CCM of 4.1.3

Both locations are connected via a VPN tunnel

--- The Tunnel is set to allow traffic from both voice networks. it is setup to allow tcp/up (all ports)

I created the sip trunk in ccm on both servers. I created the CCS and route pattern to test between both sides.

I can call each side, it answers. But I cannot hear any voice

I can hear DTMF tones when pressed but no audio.

I also see some werid issues with call hold and stuff but i am assuming thats the Limited SIP compat in the verison of call manager

Remote site - PIX 515

Main site - ASA 5520

2 REPLIES
New Member

Re: Sip trunks between two CCM 4.1.3

create h323 gateway

New Member

Re: Sip trunks between two CCM 4.1.3

I wish I could, I cant. We are having several companys use SIP trunks right to our system to save on over seas calling.

weird thing

I installed wireshark on the PC running a IP communicator (My test phone)

I loaded everything to monitor test calls and enabled traces. Now I test and it works. I cannot place calls o hold now. When I do I cannot retreive them. I have the MTP checked on both sides of the SIP trunk and it still will not put them on hold.

I know most people say to use 5 or 6 for this. We are still on 413

115
Views
0
Helpful
2
Replies