Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sip-ua with sipgate Germany

Hi Guys,

I try to implement Sipgate (Germany) as ISTP.

I see that the trunk get registred with:

- show sip-ua register status

- configuration website from Sipgate

Unfortunately the registration drops, the status of the trunk from the website is offline but show sip-ua register status tell me the trunk is registered.

I use this cfg on gateway:

voice service voip

ip address trusted list

  ipv4 217.10.68.150 255.255.255.255

no ip address trusted authenticate

allow-connections h323 to h323

allow-connections h323 to sip

allow-connections sip to h323

allow-connections sip to sip

sip

  bind control source-interface GigabitEthernet0/0

  bind media source-interface GigabitEthernet0/0

  min-se 28800 session-expires 28800

  bearer-capability clear-channel udi

sip-ua

credentials number 111111T0 username 111111T0 password 7 XXXXXXX realm sipconnect.sipgate.de/111111T0

authentication username 111111T0 password 7 XXXXXXX realm sipconnect.sipgate.de/111111T0

retry invite 5

retry register 10

timers connect 100

registrar dns:sipconnect.sipgate.de:5060 expires 3600

sip-server dns:sipconnect.sipgate.de:5060

dial-peer voice 50 voip

translation-profile outgoing SIP

destination-pattern 41T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

session protocol sipv2

session target sip-server

session transport udp

dtmf-relay rtp-nte

codec g711ulaw

If the trunk is registered on both sides, incoming calls working fine.

But outgoing calls doesn't work at all.

So currently I'm facing two issues:

1. registeration drops

2. outgoing calls don't work --> SIP/2.0 403 Forbidden (check from field)

For the frist issue, this output lookings strange to me:

VGW_1#show sip register stat

Line                             peer       expires(sec) registered P-Associ-URI

================================ ========== ============ ========== ============

0*                               2          125          no        

111111T0                         -1         2202         yes       

I don't know where the 0* is coming from. But it also tries to register at Sipgate Oo

For the second issue, I guess it would work if I could use this cfg on outgoing SIP dial-peer:

clid network-number 111111T0

But I can't implement it, because there is a letter in it.

Running IOS version: 15.1(4)M1

Please advise

Everyone's tags (5)
1 REPLY
Hall of Fame Super Gold

sip-ua with sipgate Germany

Wrong forum, post in "IP telephony". You can move your posting with the Actions panel on the right.

579
Views
0
Helpful
1
Replies