Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sipgate Trunk with CME

Hey everyone,

I try to connect CME with Sipgate Trunk. For sipgate you need to send your sipgate user id as clid network-number. This works fine with a normale sipgate account because it has only numbers. But as a Sipgate Trunk Customer you get a user id with one letter inside, it's look like this: 1234567t1.

Is there any workaround to send this user id as the network caller-id?

dial-peer voice 1 voip

translation-profile incoming SIP-IN

translation-profile outgoing SIP-OUT

destination-pattern .T

session protocol sipv2

session target dns:sipconnect.sipgate.de

dtmf-relay sip-notify

####

clid network-number <???????>

###

!

!

sip-ua

credentials username 1234567t1password 7 xxxxx realm sipconnect.sipgate.de

authentication username  1234567t1password 7 xxxxx realm sipconnect.sipgate.de

no remote-party-id

registrar dns:sipconnect.sipgate.de expires 3600

sip-server dns:sipconnect.sipgate.de

!

christian

- Please rate helpful posts -
1 REPLY
New Member

I know this was posted 4

I know this was posted 4 years ago, but I came across this post when searching for a solution and was disappointed to find no answer.

 

Here's the solution thats working for me:

http://www.packetnerd.com/?p=114

 

Manually swapping out the user ID in the sip invite works fine on my sipgate.co.uk account.

895
Views
0
Helpful
1
Replies