Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SIT trunk with mutiple numbers

Hi,

I received from my sip provider 2 numbers.

They are configured in the following way:

sip-ua

credentials username xxxxx password 7 xxxxxxx realm xxxxx

credentials username xxxxx password 7 xxxxxxx realm xxxxx

The dial peer is:

dial-peer voice 1 voip

destination-pattern 0.........$

session protocol sipv2

session target dns:xxxxxx

voice-class codec 1

The problem is that i can only use one line.If the first line is used for an outbound call it will not fall back to the seccond line for the second outbound call.

Is there a way to do this, fallback between the two lines?

(or in case of multiple FXO lines how is this accomplished? how can you configure one dial peer to use more fxo ports?)

Thank you,

laszlo

165
Views
0
Helpful
0
Replies