Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Slips on Gateway

How can I check my timing on the gateway or set it? Provider says the line looks good but the slips keep comming through.

4 REPLIES

Re: Slips on Gateway

Michael,

You can do a "show controller t1" on the router and see if you are getting slip errors. If so, issue the following command:

network-clock-participate wic X

network-clock-select 1 t1 X/X/X

I hope this helps.

kb

Community Member

Re: Slips on Gateway

I will give this a try thank you. I am assuming the X stands for interface and port numbers?

Re: Slips on Gateway

Yes...

VIP Super Bronze

Re: Slips on Gateway

Michael,

Use the following command to check the source of your clocks..

show network-clocks

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
153
Views
0
Helpful
4
Replies
CreatePlease to create content