Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP Configuration on CUCM 7.1

Hi,

I am tryin to configure SNMP on the CUCM Servicability page. I am able to add SNMP string in the Page for the CUCM servers. But when I add the SNMP destination in the Page and save it, i am unable to view the destination listed when i search for it. Very strange. Can anyone guide me on this???

Also when I followed the SNMP troubleshooting guide for the SNMP walk i get the following error

admin:snmp walk -c abcde -v2c 191.81.103.101 1.3.6.1.4.1.9.9.156.1.1.2

Invalid command, a dash character must be preceded by an alphanumeric character

Has any1 faced this error? How do i move further?

The SNMP service is started on all the servers. I have tried stopping and starting the SNMP services also, but in vain!!!

Do let me know if any more info is needed.

Regards

Sridhar

606
Views
0
Helpful
0
Replies