Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SNMP E1/PRI

Hello!

We have Cisco 2851 with two VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1

!

card type e1 0 0

card type e1 0 2

!

I want monitoring active calls, but can see only for card 0/0:

# snmpwalk -c public -v 2c ROUTER 1.3.6.1.4.1.9.10.19.1.1.9

SNMPv2-SMI::enterprises.9.10.19.1.1.9.1.3.0.0 = Gauge32: 2

SNMPv2-SMI::enterprises.9.10.19.1.1.9.1.3.0.1 = Gauge32: 0

What can i do to start monitoring my card 0/2?

4 REPLIES
Community Member

Re: SNMP E1/PRI

Anybody.. up

Cisco Employee

Re: SNMP E1/PRI

Cisco Employee

Re: SNMP E1/PRI

Scratch that. I just realized the ISR series routers do not support the CISCO-POP-MGMT-MIB.

Researching still...

Regards,

Michael.

Cisco Employee

Re: SNMP E1/PRI

So the issue of ISR routers not supporting CISCO-POP-MANGAGEMENT MIB is documented in CSCee16176. You may want to use the CISCO-ISDN-MIB instead.

Regards,

Michael.

637
Views
0
Helpful
4
Replies
CreatePlease to create content