Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP traps

Dear all,

I am using CCM 6.1. and In my network we are using third party NMS( Tivoli).

I want to send the traps for IP Phones to that NMS.

For that what I should configure in my CCM.

Ip attaching, what I have done for SNMP configuration in my CCM.

any body is there to help me out.

Thanks & regards

Madhab

3 REPLIES
Cisco Employee

Re: SNMP traps

You have to enable clogNotificationsEnabled (1.3.6.1.4.1.9.9.41.1.1.2) and then the traps will be sent to their destination as defined.

Joe

New Member

Re: SNMP traps

Dear Joe,

Thanks for your reply.

can you tell me from which option I can enable that ClogNotification .

thanks & regards

madhab

Cisco Employee

Re: SNMP traps

Hi Madhab,

For any dos prompt:

To enable trap (clogNotificationsEnabled) : snmpset -c public -v 2c 1.3.6.1.4.1.9.9.41.1.1.2.0 i 1

To change the trap severity (clogMaxSeverity) : snmpset -c public -v 2c 1.3.6.1.4.1.9.9.41.1.1.3.0 i 4

In above example last value 4 means set the severity to 4 (Error). In this example any syslog event with severity emergency(1),alert(2),critical(3),error(4) will generate the syslog trap.

Joe

245
Views
0
Helpful
3
Replies