02-09-2010 02:28 AM - edited 03-18-2019 11:03 AM
Hi,
I have a CISCO IP Phone 7960 with a 7914 Expansion Module, so that the secretary can monitor and overview the persons that she has configured on the 7914 Expansion Module.
The only downside is that when a person calls one of the numbers that she has configured on the 7914 Expansion Module, and then her phone also rings.
Is there any way that I can configure her phone or expansion module, so her phone does not ring, if someone tries to call one of the persons on her list?
Instead of ringing, it should just flash red and yellow the button.
Kind regards,
Carl-Marius
Solved! Go to Solution.
02-09-2010 05:33 AM
Hi Carl-Marius,
You should be able to go to the individual DN settings for each
of the lines on the 7914 and change the Ring Setting (Phone Idle)
to Flash Only (from Brugsystemstandard).
Cheers!
Rob
02-09-2010 05:33 AM
Hi Carl-Marius,
You should be able to go to the individual DN settings for each
of the lines on the 7914 and change the Ring Setting (Phone Idle)
to Flash Only (from Brugsystemstandard).
Cheers!
Rob
02-11-2010 04:17 AM
Hi Rob,
Thank you very much for the fast and precise answer, it worked!
Kind regards,
Carl-Marius
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: