I'm trying to configure an SPA3102 with as asterisk box.
I'm having an issue with the disconnect tone detection.
Right now I can have two configurations, one:
* If I receive a call on the PSTN and the caller disconnects before I answer the SPA3102 doesn't detect the disconnection and phones continue ringing. This configuration has a PSTN Ring Timeout very high (600).
another: * If I receive a call the phone rings for 5 seconds, stops, rings agains a couple seconds, stops, rings again, and continues like this until the caller disconnects. This configuration has a PSTN Ring Timeout with a default value (5).
I tried changing the Disconnect Tone with a lot of values I got from many places (including the values from www.3amsystems.com). I also tried with different FXO Port Impedance values.
I can't understand either why SAP3102 with an high PSTN Ring Timeout doesn't disconnect the call, and why it does a loop with ringing on the phone with the PSTN Ring Timeout set to low.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...