Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Spain PRi configuration

Hi all,

does anyone knows what are the paremeters for configure a Pri line throught MGCP in a Callmanager?

(PRI Protocol Type, line codinf, framing, ...)

thanks in advance

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Spain PRi configuration

Like all European contries, switchtype primary-net5, linecode hdb3, framing usually crc4.

hope this helps, please rate post if it does!

4 REPLIES
Hall of Fame Super Gold

Re: Spain PRi configuration

Like all European contries, switchtype primary-net5, linecode hdb3, framing usually crc4.

hope this helps, please rate post if it does!

New Member

Re: Spain PRi configuration

that's correct, the problem was that I selected a T1 interface instead E1 one. therefore this parameters didnt appear. Now it's correct.

thank you very much for your faster answer.

Hall of Fame Super Gold

Re: Spain PRi configuration

You're welcome, please remember to rate posts using the scrollbox below!

New Member

Re: Spain PRi configuration

thanks again,

Do you Know how can I receive all calls (from this Pri line) in a Line Group?

The MGCP gateway is configured.

The line group is Configured.

126
Views
0
Helpful
4
Replies