07-27-2011 06:06 PM - edited 03-16-2019 06:10 AM
Hi, I'd like to enable 'Span to PC Port' on a cisco 7941 - [Settings - Device Configuration - Ethernet Configuration - Span to PC Port] so we can have a look at the traffic with an analyser and ensure the TOS value is correct.
We are using v7.1.3 CUCM
Phone load file SCCP41.8-5-3S
How do you go about this?
Thanks in advance,
Brendan
Solved! Go to Solution.
07-27-2011 06:34 PM
Hi Brendan,
Check out the following post: https://supportforums.cisco.com/message/1172757#1172757
The following settings can be found in CUCM by going to Device > Phone and selecting the appropriate phone:
PC Port set to enabled
PC Voice VLAN Access set to enabled
Span to PC Port set to enabled
HTH,
Chris
07-27-2011 06:34 PM
Hi Brendan,
Check out the following post: https://supportforums.cisco.com/message/1172757#1172757
The following settings can be found in CUCM by going to Device > Phone and selecting the appropriate phone:
PC Port set to enabled
PC Voice VLAN Access set to enabled
Span to PC Port set to enabled
HTH,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide