Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Span to PC Port - Cisco 7941

Hi, I'd like to enable 'Span to PC Port' on a cisco 7941 - [Settings - Device Configuration - Ethernet Configuration - Span to PC Port] so we can have a look at the traffic with an analyser and ensure the TOS value is correct.

We are using v7.1.3 CUCM

Phone load file SCCP41.8-5-3S

How do you go about this?

Thanks in advance,

Brendan

1 ACCEPTED SOLUTION

Accepted Solutions

Span to PC Port - Cisco 7941

Hi Brendan,

Check out the following post:  https://supportforums.cisco.com/message/1172757#1172757

The following settings can be found in CUCM by going to Device > Phone and selecting the appropriate phone: 

PC Port  set to enabled

PC Voice VLAN Access set to enabled

Span to PC Port set to enabled

HTH,

Chris

1 REPLY

Span to PC Port - Cisco 7941

Hi Brendan,

Check out the following post:  https://supportforums.cisco.com/message/1172757#1172757

The following settings can be found in CUCM by going to Device > Phone and selecting the appropriate phone: 

PC Port  set to enabled

PC Voice VLAN Access set to enabled

Span to PC Port set to enabled

HTH,

Chris

3900
Views
5
Helpful
1
Replies