01-10-2012 07:35 AM - edited 03-16-2019 08:55 AM
I have a UC500 with a Catalyst 3560-24PS switch conected to the expansion port as a dot1q trunk.
the SPA502G wors fine directly connected to the uc500.
When I plug the 502G phone to the 3560 switch, it doesnt work.
Is the SPCP exclusive for the Smart Business switches like CE-500 ?
Thanks.
01-10-2012 07:38 AM
No. Either UC500 or the 3560 are not configured correctly.
01-10-2012 08:29 AM
Thanks Paolo, can you give me the trick?..
the following is the configuration on the interfaces:
uc500
!
interface FastEthernet0/1/7
switchport access vlan 192
switchport voice vlan 10
macro description cisco-phone | cisco-phone | cisco-phone
spanning-tree portfast
!
EXPANSION PORT ON UC500
interface FastEthernet0/1/8
switchport trunk allowed vlan 1-189,191-4094
switchport mode trunk
!
switch
!
interface FastEthernet0/1
switchport access vlan 192
switchport mode access
switchport voice vlan 10
spanning-tree portfast
!
!
TRUNK on the switch
interface FastEthernet0/21
description UPLINK TO UC520 Expansion Port
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1-189,191-4094
switchport mode trunk
end
01-10-2012 08:32 AM
Seems fine. Check what the phone is actually doing, if it gets an address, (show cdp neig)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide