Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Speed Dial Changed with CCM 6

Hi

We have an integration between CCM6 and Siemens. So, we use one route 50 to use a special lines on Siemens. This works fine.

My doubt.

On ccm 4.2, we created same speed dials with 50, so when I clicked the speed dial I listen the dial tone and I call the number.

Run DMA

Upgrade to 6

Now I click the speed dial with 50 and...."Your call cannot complete as dial".

The concept of speed dial changed with the callmanager versions?

Thanks

Peterson

1 REPLY
New Member

Re: Speed Dial Changed with CCM 6

Hi

On ccm 6 on System->Service Parameters->Call Mananager.

ON option Speed dial Await Further Digits set to True. So, the speed dial wait the digits before the complete call.

Tks

Peterson

154
Views
0
Helpful
1
Replies