Thanks for the reply, they are certainly useful queries to be able to run.
However it doesnt give me the results I am after.
If a phone has a 7914 attached to it and is configured for, lets say, 15 lines in total I need to run a query that will show that line 1 has extn 1234 configured, line 2 has extn 2345 configured, line 3 is blank, line 4 has 4567 configured,etc etc.
Then I will be able to see that if an extn has 15 lines on it but only 6 have anything configured on them I can take the 7914 from that user as they no longer need it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...