Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST Access code

Hi,

i beleive i have read it somewhere on the forum before but i could not find it again.

I have CCM 4.13 and VG 2811 in SRST fall back.

Normal behavior, end user dials 9 for access code and hear tone as soon as he dials 9.

in SRST mode (i configured the access code 9 of course) it takes long time to hear back the tone and the end user feel something wrong (it could take like 7 seconds).

Is there any way to reduce this timing?

Good day

2 ACCEPTED SOLUTIONS

Accepted Solutions
Gold

Re: SRST Access code

under the SRST config, can you try "secondary-dialtone 9" and see if that helps

New Member

Re: SRST Access code

The delay is because of the 9T configured in the Dial-peer. By configuring 9T, the system waits for the inter digit timeout. I think the default value is 10 second. Try the following:

Dial-peer voice 1 pots

Description Local Calls

destination-pattern 9[2-9].........

port 0/0/0

forward-digits 10

Dial-peer voice 2 pots

Description Long Distance

destination-pattern 91[2-9].........

port 0/0/0

forward-digits 11

This is an example for local and Long Distance calls. You need to configure a Dial-Peer matching the international calls as well.

8 REPLIES
Gold

Re: SRST Access code

sounds more like u have an overlapping Dialplan. Do a show dial-peer voice summary and check for the overlap. The best option is to aviod overlap instead of playing with timers

New Member

Re: SRST Access code

uhmmm,

well i have more than one dial peer with each point to an FXO (Voice port).

Dial-peer voice 1 pots

destination-pattern 9T

port 0/0/0

Gold

Re: SRST Access code

can u attach the output of "show dial-peer voice summary" and "show call-manager-fallback all"

New Member

Re: SRST Access code

Hi Mahesh,

I will send them tomorro as i have no access to my customer's remotly.

thanks Mate for your help

Good day

New Member

Re: SRST Access code

Attached are the files you asked for.

Good day

Gold

Re: SRST Access code

under the SRST config, can you try "secondary-dialtone 9" and see if that helps

New Member

Re: SRST Access code

The delay is because of the 9T configured in the Dial-peer. By configuring 9T, the system waits for the inter digit timeout. I think the default value is 10 second. Try the following:

Dial-peer voice 1 pots

Description Local Calls

destination-pattern 9[2-9].........

port 0/0/0

forward-digits 10

Dial-peer voice 2 pots

Description Long Distance

destination-pattern 91[2-9].........

port 0/0/0

forward-digits 11

This is an example for local and Long Distance calls. You need to configure a Dial-Peer matching the international calls as well.

New Member

Re: SRST Access code

The secondary dial tone did the JOB.

Thanks and Good day

205
Views
0
Helpful
8
Replies
CreatePlease login to create content