Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SRST and UCCCX

We have a CUCM Business edition ver 7.0

and srst ver 7 voice gateway with UCCX ver 5.0

In event of Business edition failing, we have got SRST configured on the Gateway.

Is there a way that I can configure the voice gateway to be able to use the UCCX.

2 ACCEPTED SOLUTIONS

Accepted Solutions
New Member

Re: SRST and UCCCX

Personally, I would consider using the B-ACD TCL script on the gateway. That way you can have resilience against UCCX failure as well (or even get rid of it completely :-)

Hall of Fame Super Silver

Re: SRST and UCCCX

Unfortunately it's not that simple as UCCX does not include H323 nor SIP protocols, so dial-peers can not be used.

UCCX uses JTAPI for call control for which you need either CallManager or CallManager Express.

HTH,

Chris

5 REPLIES
Bronze

Re: SRST and UCCCX

There is no way to do that since you can't have JTAPI integration with SRST. I would make sure you have the alias command under call-manager-fallback and have inbound numbers at least his an extension during a failover.

Hall of Fame Super Silver

Re: SRST and UCCCX

You could run SRST as CME, but UCCX can be integrated with one or the other. So as an alternative you can implement second UCCX server and integrate it with CME (SRST).

Alternatively you can configure BACD on the router as a backup when site is in CME (SRST) mode.

Chris

New Member

Re: SRST and UCCCX

thanks for the responses, actually all I need to do is run a script on uccx that is for out of hours, we don't have any agents.

SO I am guessing I just need a dial peer

poinitng to the UCCX server?

New Member

Re: SRST and UCCCX

Personally, I would consider using the B-ACD TCL script on the gateway. That way you can have resilience against UCCX failure as well (or even get rid of it completely :-)

Hall of Fame Super Silver

Re: SRST and UCCCX

Unfortunately it's not that simple as UCCX does not include H323 nor SIP protocols, so dial-peers can not be used.

UCCX uses JTAPI for call control for which you need either CallManager or CallManager Express.

HTH,

Chris

308
Views
0
Helpful
5
Replies
CreatePlease to create content