Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST Call Rollover in Fallback Mode

I'm working on a 3825. I have 2 7960 phones in fallback mode. The main ext is 52720. When I make a call from one phone on ext 52723 to 52720 I pickup. Then when I call on a second line 42723 to 52720 it doesn't rollover to 1st rollover which is 42720. It will just ring on 52720 as a call wait. I can make this happen with the call-forward noan statement in the config, but it needs to be busy, not noan. It also needs to rollover and ring forever and not hangup after a timeout. I've tried all sorts of combinations and could use some guidance. This is what I have for call-manager-fallback:

call-manager-fallback

secondary-dialtone 9

max-conferences 24 gain -6

transfer-system full-consult

ip source-address 10.136.64.50 port 2000

max-ephones 336

max-dn 960 dual-line preference 3

transfer-pattern 5....

default-destination 52720

call-forward busy 4....

moh MOH122304.ULAW.wav

1 REPLY

Re: SRST Call Rollover in Fallback Mode

Hello,

Try removing the dual-line from the max-dn statement, and then call-forward busy to 42720.

Hope that helped, if so please rate.

478
Views
0
Helpful
1
Replies