Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRST configuration on Voice Gateway

Hi,

I configured Fallback on my h 323 voice gateway and verified by denying a couple of phones communicating with CUCM through access-list and it works fine but calls are not going through both outgoing as well as incoming.

Trying to configure the SRST on the existing H323 Voice Gateway.

Please let me know whether my testing way is fine or it needs a different way to test my fallback service.

  • IP Telephony
12 REPLIES

SRST configuration on Voice Gateway

Hi Harish.

Please post your VG configuration and specify where did you applied the access-list

Thanks

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"
New Member

Re: SRST configuration on Voice Gateway

Hi Carlo,

Thanks for u r response, I had applied my access-list on the core switch to deny the communication b/w couple of phones and the CUCM cluster.

Here below is my config:

call-manager-fallback

secondary dialtone 9

max-conferences 8 gain -6

transfer-system full-consult

ip source-address 10.x.x.x port 2000

max-ephones 250

max-dn 500.

Phones are registering to Voice gateway but calls are not going through.

only 2 phones are denied other phones as well as gateway is communicating to CUCM.

Any additional dial-peers required for SRST configuration on voice gateway to forward calls, I read in few blogs there is no need of additional dial-peers and it will use the existing dial-peers only to route the calls.

New Member

Re:SRST configuration on Voice Gateway

Show output of the "show voip dialpeer inout"


Sent from Cisco Technical Support Android App

New Member

SRST configuration on Voice Gateway

I am not able to execute this command on the voice gateway...

Re: SRST configuration on Voice Gateway

Hi.
Omer meant debug voip dialpeer inout during an incoming or outgoing call from or to an ip phone in srst mode


Regards
Carlo

Sent from Cisco Technical Support iPhone App

Please rate all helpful posts "The more you help the more you learn"
New Member

Re: SRST configuration on Voice Gateway

Thanks Mr. Carlo. I apologize as its my mistake.

I meant to say show the output of "debug voip dialpeer inout" & "debug voip ccapi intout"

New Member

SRST configuration on Voice Gateway

Hi,

I checked and as per the stats my outgoing calls are not matching with the existing dial-peers at all.

Hi Omar/Carlo - At wat time either of u guyz will be free to discuss this on live chat..

Re: SRST configuration on Voice Gateway

Hi.
I could be free at 21 GMT.
Let me know

Carlo

Sent from Cisco Technical Support iPhone App

Please rate all helpful posts "The more you help the more you learn"
New Member

SRST configuration on Voice Gateway

Here below is debug voice dail-peer for incomoing call from pstn.

an  7 11:39:20.206: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore:

   Calling Number=0552017119, Called Number=0554, Voice-Interface=0x4955DEE0,

   Timeout=TRUE, Peer Encap Type=ENCAP_VOICE, Peer Search Type=PEER_TYPE_VOICE,

   Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.206: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore:

   Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming Dial-peer=22

*Jan  7 11:39:20.206: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore:

   Calling Number=0552017119, Called Number=0554, Voice-Interface=0x0,

   Timeout=TRUE, Peer Encap Type=ENCAP_VOICE, Peer Search Type=PEER_TYPE_VOICE,

   Peer Info Type=DIALPEER_INFO_FAX

*Jan  7 11:39:20.206: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore:

   Result=NO_MATCH(-1) After All Match Rules Attempt

*Jan  7 11:39:20.206: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Calling Number=, Called Number=0554, Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.206: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Match Rule=DP_MATCH_DEST; Called Number=0554

*Jan  7 11:39:20.206: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Result=Success(0) after DP_MATCH_DEST

*Jan  7 11:39:20.210: //-1/xxxxxxxxxxxx/DPM/dpMatchPeers:

   Result=SUCCESS(0)

   List of Matched Outgoing Dial-peer(s):

     1: Dial-peer Tag=22

     2: Dial-peer Tag=5555

*Jan  7 11:39:20.218: //-1/2E81982B8811/DPM/dpMatchPeersCore:

   Calling Number=, Called Number=0554, Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.218: //-1/2E81982B8811/DPM/dpMatchPeersCore:

   Match Rule=DP_MATCH_DEST; Called Number=0554

*Jan  7 11:39:20.218: //-1/2E81982B8811/DPM/dpMatchPeersCore:

   Result=Success(0) after DP_MATCH_DEST

*Jan  7 11:39:20.218: //-1/2E81982B8811/DPM/dpMatchPeersMoreArg:

   Result=SUCCESS(0)

   List of Matched Outgoing Dial-peer(s):

     1: Dial-peer Tag=22

     2: Dial-peer Tag=5555

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Calling Number=0554, Called Number=0554, Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Match Rule=DP_MATCH_DEST; Called Number=0554

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Result=Success(0) after DP_MATCH_DEST

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersMoreArg:

   Result=SUCCESS(0)

   List of Matched Outgoing Dial-peer(s):

     1: Dial-peer Tag=22

     2: Dial-peer Tag=5555

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Calling Number=0554, Called Number=0554, Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Match Rule=DP_MATCH_DEST; Called Number=0554

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Result=Success(0) after DP_MATCH_DEST

*Jan  7 11:39:20.218: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersMoreArg:

   Result=SUCCESS(0)

   List of Matched Outgoing Dial-peer(s):

     1: Dial-peer Tag=22

     2: Dial-peer Tag=5555

*Jan  7 11:39:20.222: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore:

   Calling Number=0554, Called Number=, Voice-Interface=0x0,

   Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search Type=PEER_TYPE_VOICE,

   Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.222: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore:

   Result=Success(0) after DP_MATCH_ORIGINATE; Incoming Dial-peer=5555

*Jan  7 11:39:20.222: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Calling Number=, Called Number=0554, Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.222: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Match Rule=DP_MATCH_DEST; Called Number=0554

*Jan  7 11:39:20.222: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersCore:

   Result=Success(0) after DP_MATCH_DEST

*Jan  7 11:39:20.222: //-1/xxxxxxxxxxxx/DPM/dpMatchPeersMoreArg:

   Result=SUCCESS(0)

   List of Matched Outgoing Dial-peer(s):

     1: Dial-peer Tag=22

     2: Dial-peer Tag=5555

*Jan  7 11:39:20.222: //-1/2E81982B8811/DPM/dpMatchPeersCore:

   Calling Number=, Called Number=0554, Peer Info Type=DIALPEER_INFO_SPEECH

*Jan  7 11:39:20.222: //-1/2E81982B8811/DPM/dpMatchPeersCore:

   Match Rule=DP_MATCH_DEST; Called Number=0554

*Jan  7 11:39:20.222: //-1/2E81982B8811/DPM/dpMatchPeersCore:

   Result=Success(0) after DP_MATCH_DEST

*Jan  7 11:39:20.222: //-1/2E81982B8811/DPM/dpMatchPeersMoreArg:

   Result=SUCCESS(0)

   List of Matched Outgoing Dial-peer(s):

     1: Dial-peer Tag=22

     2: Dial-peer Tag=5555

332
Views
0
Helpful
12
Replies
This widget could not be displayed.