Currently, we have to seperate sites (130 users each)with two seperate Gateways and PRI's but are moving all the users into a single site in downtown. We will have two PRI's in the new site. I would like to be able to use both existing GW's in the new site. In order to avoid additional configuration, I am planning to keep the same design which is as follow:
PRI1---->GW1(2821)---->CCM5.1---->Phone1 (Simulating Site #1 in the new site)
PRI2---->GW2(2821)---->CCM5.1---->Phone2 (Simulating Site #2 in the new site)
Although both gateways are seated in the same rack but don't know about each other. They will be serving their own and respective users as they used to do on the old sites. My questions:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...