I need help figuring out if it is possible to have an internal incoming call while being off_net and the first line being on a call, have the call roll over to the second rollver. Right now while being in Fallback mode I can call ext to ext but when another call comes into the main ext, the call does a call wait feature and doesn't rollover to the next line after 30 rings and then it hungs up. I have CCM 4.1(3), IOS 12.4(22)T and using 7960's (G) with firmware 8.0.
I have a 3825 with 2 FXO cards. I have two trunk lines in 0/0/0 and 0/0/1. I can make incoming and outgoing no problem. It's when I go off_net and plug 2 Cisco 7960's into a test Cisco switch and plug a patch cord from the Switch to the GE 0/0 port. My phones grab an IP locally from SRST and go into Fallback mode. I test call from ext 52723 on one phone to ext 52720 on the other. The call internally works fine. But when I answer the call on 52720 and place it on hold on 52723, then go to another line 42723 and try to call 52720, it will come in on the same line as a call wait and not roll over to 42720 which is the rollover. This is what my Call-Manager-fallback looks like:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...