Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SRST from the start

I went on a job interview and was asked what are the first two commands you put in the router for SRST. When the routers were set up for this I did it with a partner years ago (4 Years ago). Well i dident know the answer to the question and I have been searching for the answer. The person asking me said "once the commands are put in the do not show up on the config." I can not find these any place even though I have found alot on SRST.

Its good to get this down for my own general knowledge but I can seem to find this answer. Can some one tell me or point me in the best direction.

Chris

1 REPLY
Cisco Employee

Re: SRST from the start

There are three commands you need for a minimal SRST configuration -

call-manager-fallback

ip source address

max-ephones

max-dn

The values for max-ephones and max-dn are platform dependent. Refer here for more details -

http://my.safaribooksonline.com/158705258X/ch13lev1sec2

All these commands show up in the config.

You might be able to go back the prospective employer and argue the point :-)

136
Views
0
Helpful
1
Replies
CreatePlease to create content