Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRST FXS Ports

I am setting up a router to run SRST with 2 FXO ports for outbound dialing. How do I get the router to use both ports. Example Port 1 is used (on a call) will the next call go to port 2? Do I just need to setup matching dial peers going to each FXO port?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: SRST FXS Ports

Yes, use mutliple dial peers with the "preference" command such as:

dial-peer voice 1 pots

destination-pattern 9T

port 0/0/1

dial-peer voice 1 port

destination-pattern 9T

port 0/0/2

preference 1

The default preference is 0 and the lower preference takes precedence.

Hope this helps.

Brandon

1 REPLY

Re: SRST FXS Ports

Yes, use mutliple dial peers with the "preference" command such as:

dial-peer voice 1 pots

destination-pattern 9T

port 0/0/1

dial-peer voice 1 port

destination-pattern 9T

port 0/0/2

preference 1

The default preference is 0 and the lower preference takes precedence.

Hope this helps.

Brandon

144
Views
0
Helpful
1
Replies