Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRST help

    Hi guys,

I'll need some help configuring SRST.

I've set the call-manager-fallback command like this:

call-manager-fallback
secondary-dialtone 9
max-conferences 12 gain -6
transfer-system full-consult
ip source-address 10.10.0.2 port 2000
max-ephones 300
max-dn 500
system message primary SRST Fallback Active
system message secondary SRST Fallback
dialplan-pattern 1 04222..... extension-length 5

I can talk between DN but I can't get call outside.

I have a PRI link

Is there anything else that I have to configure ?

Thanks

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: SRST help

you must configure a pots dial peer for outgoing call

example:

dial-peer voice 1 pots

desc outgoing SRST

destination-pattern 9T

port 0/0/0:15

6 REPLIES
New Member

Re: SRST help

you must configure a pots dial peer for outgoing call

example:

dial-peer voice 1 pots

desc outgoing SRST

destination-pattern 9T

port 0/0/0:15

New Member

Re: SRST help

I configured it but still not working.

dial-peer voice 11 pots
destination-pattern 9T
direct-inward-dial
port 0/3/1:15
forward-digits all

New Member

Re: SRST help

what say

debug isdn q931

if you dial a number to PSTN?

New Member

Re: SRST help

i've set the debug but nothing happens when I try to call.

I solved it. The port setting was not right.

Thanks

New Member

Re: SRST help

Hi. I've the same problem.

Can You explain me what did You corect in port settings.

When my SRST router has been restarted due to power interraptions I've loss access to PSTN.

thank's

Alex

New Member

Re: SRST help

Hi Alex,

Well, the serial port that I specified was wrong. I checked the router and set the correct port.

Please put your config here maybe I can help.

Adrian

432
Views
0
Helpful
6
Replies
CreatePlease to create content