Hello, I'm currently experiencing an issue with SRST. In an environment of about 160 phones 15 are in a SRST Device Pool (whose SRST refence is configured correctly..[IP for Gateway is correct, port is 2000 & Cert port is 2445]..). All phones seem to switch fine into SRST mode, but only one phone will receive calls/ring.
Thanks for the suggestion we finally figured it out. simple mistype problem in the Gateway configuration. all we needed was a day off and when we took a look at it again the problem was staring us in the face :)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...