I have a customer requirement for SRST across a few sites, with the main aim to provide 100% coverage for all users. I am concerned however around the maximum supported users on the 3825 and 3845.
Some of the sites I am quoting for go above the 240 user mark which seems to be the default on the 3845, but I have seen a tab within the configuration tool which allows you to add in additional user licences up to a staggering 720 users!!
If I provide a 3845 which needs to support 280 users, can all of these users log on when in a SRST situation? All of the routers will only have enough PVDM?s and ISDN30e channels to service 30 concurrent users, but I am concerned that any user above 240 will not be able to log on!
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.