I am simulating a failure on our UC 6 system, and the IP Phones have successfully gone into CM Fallback Service Operating mode. However, when I dial a number, it only accepts 4 digits and then tries to set up the call.
Below is the config:
max-conferences 8 gain -6
ip source-address 172.28.3.254 port 2000
dialplan-pattern 1 011256.... extension-length 4
call-forward busy 9000
call-forward noan 9000 timeout 15
multicast moh 126.96.36.199 port 16384
Is the dialplan-pattern config correct?
On the CUCM phones are configured with 4 digit extensions and have the 011256XXXX masked.
SIP traces provide key information in troubleshooting SIP Trunks, SIP
endpoints and other SIP related issues. Even though these traces are in
clear text, these texts can be gibberish unless you understand fully
what they mean. This document attempts to br...
Please find the attached HTML document, download and open it on your PC.
This provides an easy to use form where you simply answer a few
questions and it will render the proper jabber-config.xml file for you
to copy/paste. There is built in logic to verif...
CUCM Database Replication is an area in which Cisco customers and
partners have asked for more in-depth training in being able to properly
assess a replication problem and potentially resolve an issue without
involving TAC. This document discusses the bas...